1、本機械由船體，抽沙泵，柴油機，掛漿機，膠管，錨，六部分組成。
2、抽沙船按容量的多少分為 15 20 25 30 35 40 方抽沙船。
3、抽沙船按抽砂方式分為 自卸式抽沙船 普通式抽沙船
4、抽沙船：每小 時可從水下13米深處抽取、篩選沙60立方米/小時，船艙整體分為三體，兩頭為浮體、中間為沙艙。容量：大型抽沙船為30立方米，一般抽沙船為13立方米。行走速度為15km/小時，柴油機帶動掛漿機。
5、工作原理：抽沙船開到目的地后，用抽沙泵將沙子抽到中艙配以水槍沖沙，快速將沙子抽到中艙。滿載后將船開到岸邊，攪動渦輪減速機，船底艙門打開沙子漏到碼頭旁，再配以割邊船將沙子抽上碼頭。
6、注意事項：1、未滿十八歲及五十歲以上者不得操作或維修。
2、嚴禁未經專業培訓者或酒后操作本系列機械。
3、挖沙機檢修時，必須將全部機械停穩后，方可進行。
1, the machinery from the hull, pumping sand pump, diesel engine, hanging machine, hose, anchor, six parts.
2、抽沙船按容量的多少分為 15 20 25 30 35 40 方抽沙船。
2, pumping sand according to the capacity of the number is divided into 152025303540 side pumping sand.
3、抽沙船按抽砂方式分為 自卸式抽沙船 普通式抽沙船
3, by pumping sand pumping sand pumping sand into dump sand pumping ordinary type
4、抽沙船：每小 時可從水下13米深處抽取、篩選沙60立方米/小時，船艙整體分為三體，兩頭為浮體、中間為沙艙。容量：大型抽沙船為30立方米，一般抽沙船為13立方米。行走速度為15km/小時，柴油機帶動掛漿機。
4, pumping sand: per hour can from underwater 13 meters deep extraction, filtering sand 60 cubic meters / hour, the whole cabin divided into three, two is the floating body, in the middle of the sand compartment. Capacity: 30 cubic meters of large pumping sand pumping sand, generally 13 cubic meters. Walking speed is 15km/ hours, diesel engine drive.
5、工作原理：抽沙船開到目的地后，用抽沙泵將沙子抽到中艙配以水槍沖沙，快速將沙子抽到中艙。滿載后將船開到岸邊，攪動渦輪減速機，船底艙門打開沙子漏到碼頭旁，再配以割邊船將沙子抽上碼頭。
5, the working principle, pumping sand open to the destination, sand pump will sand pumping match to the cabin with a water gun flushing, fast sand pumping to the tank. Loaded the ship open to the shore, stir in the turbine reducer, bottom door open sand leakage to the adjacent to the docks, with the cut edge of the ship will be pumping sand on the docks.
6、注意事項：1、未滿十八歲及五十歲以上者不得操作或維修。
6, note: 1, under eighteen years of age and above 50 years old shall not operate or service.
2、嚴禁未經專業培訓者或酒后操作本系列機械。
2, is strictly prohibited without the professional trainer or drink operation of the series of machinery.
3、挖沙機檢修時，必須將全部機械停穩后，方可進行。
3, dredging machine maintenance, must be all mechanical stop, can be carried out. |
.jpg)
